Convert CISCO Aironet AP from controller to autonomous version

Konverze z Light na Autonomous verzi

Zde je postup konverze AP - http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp160918 Kromě přímo připojeného TFTP serveru s IP 10.0.0.2 potřebujete akorát image IOSu, který vytáhnete buď z jiného AP nebo bych Vám ho někde zpřístupnil. Soubor je pak třeba přejmenovat na c1140-k9w7-tar.default

Using a TFTP Server to Return to a Previous Release

Note This section does not apply to Cisco C3201WMIC and Cisco C3201LAP.

Follow these steps to revert from LWAPP mode to autonomous mode by loading a Cisco IOS release using a TFTP server:

 - The static IP address of the PC on which your TFTP server software runs should be between 10.0.0.2 and 10.0.0.30.
 - Make sure that the PC contains the access point image file (such as c1200-k9w7-tar.122-15.JA.tar for a 1200 series access point) in the TFTP server folder and that the TFTP server is activated.
 - Set the timeout value on the TFTP server to 30 seconds.
 - On the PC where the TFTP server is located, perform these steps:
   - Disable any software firewall products, such as Windows firewall, ZoneAlarm firewall, McAffee firewall, or others.
   -Ensure all Windows files are visible. From Windows Explorer, click Tools > Folder Options > View; then uncheck the Hide extensions for known file types check box.
 - Rename the access point image file in the TFTP server folder to c1200-k9w7-tar.default for a 1200 series access point, c1130-k9w7-tar.default for an 1130 series access point, c1240-k9w7-tar.default for a 1240 series access point, and c1250-k9w7-tar.default for a 1250 series access point.
 - Connect the PC to the access point using a Category 5 (CAT5) Ethernet cable.
 - Disconnect power from the access point.
 - Press and hold MODE while you reconnect power to the access point.
 - Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds) and then release.
 - Wait until the access point reboots, as indicated by all LEDs turning green followed by the Status LED blinking green.
 - After the access point reboots, reconfigure it using the GUI or the CLI.